(It went from Scott to McCulloch to Chrysler.) Check out the Chrysler service manual for an idea of how it works. I believe the Ted Williams outboard uses the Scott system. Vintage Antique Elgin Sears Outboard Boat Motor Parts Or Repair. Nos Sears Elgin Outboard Motor Piston Chrysler - West Bend - 26015. Di 52027 Eska Sears Ted Williams Tecumseh Outboard Motor Carb Kit 1961- 1987. Mercury Used a hollow shaft but rotated the shift rod to change gears. New Sears Elgin West Bend 1957 - 7.5 Hp Outboard Motor Water Pump Impeller 50065. Scott Atwater used a hollow prop shaft with a step tapered cam on the end of the shift rod engaging the spring loaded dog clutch with a rod through the center of the prop shaft. OMC used a yoke coupled with a right angle lever to transfer the up and down of the shift rod to the forward & backward motion of the dog clutch. The patent was on how the clutch is moved. This is the second and third time it's been started in probably 25 years. (The motor should be idling at this time.) The dogs will then drop into spaces between the dogs in the gear. This is my grandparents Sears Ted Williams 7.5HP, air-cooled, 2-stroke outboard. When the shift lever is moved to forward, it pushes the dogs against the forward gear. McCulloch company built outboards for Sears from 1959 to 1968. The pinion drives them in opposite directions.The dog clutch is in the middle and when in neutral does not touch either one. 1965 Sear 7.5 HP Ted Williams Outboard short shaft motor - 250 (Quanicassee) For Sale 1965 Sear 7.5 HP Ted Williams Outboard short shaft motor with Forward, Neutral and Reverse, a 3 blade prop, 2.5 gallon remote tank with gas line and connector fitting including origonal owners manual. The forward and reverse gears are both engaged with the pinion gear on the drive shaft. The way a dog clutch works is to slide into spaces in the gear.
0 kommentar(er)
